primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• Through various short-circuit current temperature rise test results, the transformer temperature, time, and a high degree of three curves, obtained directly within the thermal region transformer primary winding height of about 83.3%.
  通过在不同短路电流条件下的温升试验，得到了变压器内部的温度与时间、纵向高度之间的关系曲线，得出变压器内部热区域主要集中在约绕组自下而上高度的83.3%区域。
• Relation between Relay Protection and Distribution of Secondary Winding and Outlet Way of Primary Winding in Current Transformer
  电流互感器二次绕组排列及一次绕组出线方式与继电保护的关系
• Situated within the coil's primary winding is the secondary winding.
  与初级绕组对应的是次级绕组。
• If the primary current of the transformer flows into the dotted end of the primary winding, the sencondary current will flow out of the dotted end of the secondary winding.
  如果电流从变压器的原边有标记端流入，则副边的电流从有标记端流出。
• The unbalanced degrees of current in primary winding under different load conditions are discussed, which are based on the general expressions of negative phase sequence current.
  结合负序电流的通用表达式，讨论了在不同负荷条件下的原边电流不平衡度。
• Considering the conditions as voltage at primary winding, shortcircuit forces of windings and turns for transformer were calculated with FEM coupling circuit method under the 2D symmetrical model.
  以此起始条件设定变压器原边电压激励，利用磁路-电路耦合有限元法建立了2D轴对称模型，计算了变压器原、副边线圈及各线匝短路电磁力。
• The distribution of the third harmonic magnetic field in imported large rectifier transformer is analyzed. The reason of conductor damage in winding is discussed. The overheat possibility in primary winding is expounded.
  分析了进口大型整流变压器三次谐波磁场的分布，讨论了绕组导体绝缘损坏的原因，一次绕组存在过热的可能性，提出了可采取的改进措施。
• With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
  通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
• And finally, on the basis of the magnetic integration, the application of passive integration technology, through staggered parallel structure in the primary winding of transformer in the integrated resonant capacitor, through the Maxwell 2D simulation software to validate the correctness of the design.
  最后，在平面磁集成结构的基础上，应用无源集成技术，通过交错并联结构在变压器原边中集成谐振电容，并通过Maxwell2D仿真软件验证设计的正确性。
• The inductance of primary winding, secondary winding and the mutual inductance between two windings of the models are calculated by solving the 3D magnetostatic field in the models.
  通过计算带抽能线圈并联电抗器模型的三维静磁场，得到带抽能线圈并联电抗器模型的一次、二次线圈的电感和互感等参数。